FPT Industrial Leads a Swiss Funded Project for Alternative Fuels in Heavy Duty Engines

SOURCE: CNH Industrial


Being ever more sustainable is one of the strategic objectives that FPT Industrial, a global powertrain brand of CNH Industrial N.V., is facing, and it is also a major challenge. The requirement to reach the European CO2 emission targets in 2025 and 2030 make the use of alternative fuels and e-fuels possible paths to addressing these challenges.

Following its DNA of leading research and technological innovation, the Brand’s dedicated research and development operation, FPT Motorenforschung, located in Arbon, Switzerland, is developing an innovation project into the use DME, an alternative fuel for an 11-liter heavy duty engine.

DME (Dimethyl-ether, chemical formula CH3-O-CH3) is a suitable fuel for compression ignition engines and can be produced from several renewable sources. Its chemical properties allow for, with the correct engine hardware configuration and calibration, very low NOx and particle emissions, whilst maintaining high engine efficiency. There are, however, some challenges in the use of DME as a fuel, particularly in terms of the fuel injection equipment.

DME has been industrially used for decades, mainly as a propellant in aerosol cans as it is nontoxic, odourless and can be absorbed in the troposphere. From a storage and refuelling point of view DME is like LPG (liquid petroleum gas). It is liquid at very moderate pressure levels.

The overall goal of the project is to advance the understanding of using DME as an alternative to Diesel fuel in the industrial goods sector and demonstrate clean combustion at comparable efficiency levels. Since DME combustion produces practically no particle emissions, a comparably simple Selective Catalytic Reduction (SCR) aftertreatment system, without the need for a particle filter may be enough to comply with strict emission standards.

The project is funded by SFOE (Swiss federal office for energy) and the test bench is operated at Empa Dübendorf, where the Company has invested heavily in the infrastructure adaptations necessary for DME.

The first experimental data are showing some very promising results in terms of CO2 reduction, along with very low NOx and particle emissions, together with similar engine efficiency to Diesel.

For FPT Industrial, the project contributes to the innovation activities of its Research and Development center in Arbon, Switzerland. One of its seven global R&D locations, this is the Brand’s excellence hub for advanced technologies, where both Common Rail technology and the HI-eSCR (High Efficiency Selective Catalytic Reduction system) were developed.

Tweet me: .@CNHIndustrial brand @FPTIndustrial is investigating the use of DME – a low emission fuel – for use in heavy duty industrial engines, as part of a research project funded by the Swiss Federal Office for Energy. https://bit.ly/2Mr5aqW #sustainability #lowemissions

KEYWORDS: NYSE:CNHI, CNH Industrial, Sustainability, DME, FPT Industrial

Data & News supplied by www.cloudquote.io
Stock quotes supplied by Barchart
Quotes delayed at least 20 minutes.
By accessing this page, you agree to the following
Privacy Policy and Terms and Conditions.